Hello all, I'm currently using an SRX722 over a SRX718 for small room shows. Any ideas on some sort of spacer on the stack to get the top cab up to a good height, that looks professional...Thanks
I once had same issue and I made a set of cases that held my cabs in transit and then doubled as stack spacer. I made them 2 piece designed so the lid of the case was about 1/3 the total height and I could use either the 1/3 "lid" as the spacer or the 2/3 bottom half of the case flipped upside down on top the sub with the top cab above. They were finished to match the cabs decor and looked good. Other option is simply add top hats with small pole section from sub to the tops. Those 722's have good weight distribution and with the pole socket properly installed they are very stable on a pole.
Page created in 0.102 seconds with 23 queries.